+86 769 2863 9265

Industry Information

Home > News > Industry Information

How Can We Prevent the Damage of Metal Stamping Parts?

Aug. 01, 2019

Living in the 21st century, metal stamping parts have become familiar to us. In daily life, stampings can be seen at any time, anywhere, but some metal stamping parts are easily damaged for various reasons. So what are the measures we can take to prevent the damage of these metal stamping parts?

How Can We Prevent the Damage of Metal Stamping Parts?cid=22 

Measures to prevent damage of metal stamping parts:

1. First of all, the raw materials of metal stamping parts processing, including thickness and hardness,must pass strict inspection; and should be inspected in accordance with the relevant standards before put into storage. Secondly, at the beginning of metal stamping parts processing, only the prototype has been pass the qualified testing can the products go into the mass production. While processing the metal stamping parts, we should also strengthen the inspection efforts to ensure that no defective products produced as well as correct the defect part once defective products appear. The processing of metal stamping parts also requires strict inspection on the key process and reinforce key staff training.


2. Make sure that the type, specification and performance of the hardware accessories you select shall conform to the current national standards and relevant regulations.


3. To install a metal stamping with a fastening screw, a metal liner must be built in, the thickness of which shall be at least twice the distance of the fastener. Do not fasten to plastic profiles or use non-metallic linings.


4. When installing metal stamping parts, we should pay attention to the product size and installation position to determine whether they are matching. The maintenance of metal stamping parts during the use process is also very important. We need to do anti-rust and anti-corrosion measures, but also to ensure that the degree of lubrication stamping parts, because because the damage of metal stamping part is usually caused by lubrication problems.